Saturday, November 12, 2011

Where can i find a wiring diagram for a kohler confidant 5 generator?

I have a Kohler Confidant 5 Generator out of a motor home. All the wires have been cut when removed and I was not present. there is a group of small wires coming in through a small wiring harness then 4 larger wires out ( I assume these are the output 110v but not sure of anything) can anyone inform me what the wires are or have a diagram they could email me. Thank You.|||A general approximation of wiring should be something like this.


1) 4ga Black, 12v neg (should go to engine block or generator case)


2) 4ga Red, 12v pos (should go to starter solenoid or relay)


3) 12ga blacks, a/c hots (should come out of generator end), tie together if 125 v system is wanted, use separately if 240 v system is wanted


4) 12ga whites, a/c neutrals (should come out of generator end),tie together if 125 v system is wanted, tie together and cap off for 240 v, 240 will use the two black outputs


5) Small wiring in the harness, remote control wiring? follow it inside the generator and see if it is going to the start/stop switch. If so you can dis-connect them and operate the generator from the panel.





Hope this helps you some.Good luck!

No comments:

Post a Comment